dirtybirdy

I didnt notice any difference on the center bore of the wheels I got, and yes I did use my stock lug nuts. I was planning on switching to gorilla lock nuts, but decide to spend the money elsewhere

Hey I just picked up some pro comp wheels. the part number is the same as what you stated. Is the center bore on the pro comp wheels bigger than your stock wheels too? the pro comp wheels are about 1/2" bigger diameter center bore than my stock. there's a gap between the center hub and the wheel when mounted on my truck. Also, did you re-use the stock lug nuts?

hey bud, I have a truck thats very similar to yours (lift-wise). I read that you mounted some coilovers...what all had to be done to fit those in place of the struts if you dont mind me asking? Looks clean!

looks good man. where did you get your wheels? and what specs are they? i'm finally going to pull the trigger on the lift and need to get some wheels and tires before in install it.

They are the Pro Comp Xtreme Crawler Series 52-5883F, Matte Black, Specs are 15x8, Wheel Bolt Pattern is 6x5.5, Backspacing is 3.75 with an offset of -19 mm.
Hope this helps brother.

hey man, are you wheels 3.75 Back Space with a -19 offset? I'm trying to get a picture of how wide 10.5 tires are with those specs past the fenders..

Thanks bro, Still have alot of work needed done to it, but its getting there gradually. Just got 3" Spindles over the weekend but I cant get them in until I get my extended brake lines.

Sick truck, man. Nice and clean, but still rugged