Search Results for ‘3.7l’

I have a 07 2.9L CrewCab Colorado. What’s the easiest swap and what all is needed for each? I’m wanting to do a 3.5, 3.7, or a 4.8

Hello Everyone, I have an 08 Colly LT with the 3.7 and 4wd. I started off with a engine rebuild, but due to a balancing shaft bearing going rotten and no shop that was willing to fix or try to fix the surface in for the bearing in that area, I did a low...-ish (94k miles) engine replacement in...

I just recently bought a 5.3l v8 and I’m just wondering what to expect to buy for it. Could the current wiring harness on it convert with it? What other parts may I need to swap out with it? Could the current tranny be fine with running with the 5.3l for a few months before I buy a new tranny...

see post #42, page 3

Lately I've been having a problem where occasionally while driving at low speeds often when in city traffic my truck will sputter when I need to give it light throttle. It goes away almost immediately when I speed up or slow down. I haven't been throwing any codes other than a very rare P0300...

2009+ Engine Controls and Fuel 2.9L Schematics 2009+ Engine Controls and Fuel 3.7L Schematics 2009+ Engine Controls and Fuel 5.3L Schematics

AIR INTAKE SYSTEM (LLR/3.7E) Drivelines: 2WD; 4WD; ENG: ENGINE GAS, 5 CYL, 3.7L, MFI, L5, ALUM, VVT, DOHC, GM 3.7E(LLR) PTS: PT DRESS SUBASSEMBLY INSTALLED (MODULAR OPTIMIZATION METHOD ONLY) PLANT OPERATION(JJA) RAS: REACTOR SYSTEM AIR INJECTION, ELECTRIC ELEC AIR INJECTION REACTOR(K18) AIR...

Hi everyone. I'm from Los Angeles, CA and now living in Atlanta, GA. I drove my 2007 GMC Canyon across the country three times. I bought my truck in May 2012 with 77,000 miles on it, it's now April 2015 and she has 148,739 on her now. I need to find a place here in Atlanta that would either...

I was wondering if anyone knew of any legal headers available for the 3.7L. If not, is there anyway I could modify existing headers to make them legal (adding cat after headers). I live in NY if anyone wants to know that.

So I've been searching for an hour or so and can't find this. I need to change my Crankshaft Position Sensor but I can't find where it's located. I have a 2009 3.7L I5. Can anyone tell me where it's located?

I noticed last weekend when changing the oil that there was oil all over the bottom of the engine, trans and everything else. It looks like the front crankshaft seal that's leaking! It's pretty bad, I've gone through 3 quarts in a week. Has anyone ever done the front seal on a 2010 3.7l? Any...

So, I was probably going to buy a travel trailer to live in for work. Here are the specifications for it: Dry Axle Weight (approx. Lbs.): 4215 Dry Hitch Weight (approx. Lbs.): 600 Net Carrying Capacity: 2685 Gross Dry Weight - Lbs.: 4815 Gross Vehicle Weight (GVWR) - Lbs.: 7500 If I had a...

If any of you checked out my last project, Paradox, you will see that I completed it, though not in a way that most would agree to be the better of the two possibilities. Though, like I said, with the closure of every chapter in life, another starts. Here is my next chapter. I had multiple...

looking to purchase a ( 3.7l cold air intake )and a set of ( led tail lights), also looking for ( smoked 3rd break light led lights) as well. Pm me thanks chris :salute: