Chevrolet Colorado & GMC Canyon Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Chassis
    Hello all, A few months ago, I noticed sometimes while going through left turns at around 60-65 mph, there would be a pretty bad shake in the front until I slowed down.It didn’t happen at slower speeds and it hasn’t happened for a while, but I was just curious why it was happening if anyone has...
  2. Lifting
    Hey guys, I have my torsion bars cranked to 23" from center hub to my fender flare on my 2010 4x4 Colorado. Is a ball joint flip and spacer necessary to keep my alignment in spec? I have done research and couldn't find any definite answers. Thanks in advance, Popkin
  3. I4/I5 Engine & Drivetrain
    Hello Guys, I hope this is the right place for this I did a lot of searching to hopefully find similar issues. The problem I'm having is any time one of my tires breaks free and starts to spin while I'm taking a turn, like say I'm leaving a neighborhood and i need to get to speed quickly and i...
  4. Lifting
    So I did a ball joint flip and cranked my torsion bars up for,about two inches of lift. I took it to get an alignment today and they said they couldn't do it because of the crank. And "that's not the way to lift a truck, that's what lift kits are for" But I feel like that's an excuse...
1-4 of 4 Results