Chevrolet Colorado & GMC Canyon Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-16 of 17 Results
  1. How-To/Tutorials/Reviews/Service Bulletins
    How should I get a rounded diff plug out, I have heard that you can weld something to it but I don't have access to a welder, so any advice is welcome.
  2. How-To: Performance & Maintenance
    (2006 GMC Canyon) So I just did a filter change on my transmission and now the dipstick is stuck in the hose I can move it up a little but it is most definitely stuck in there so any information on why would be nice. Thanks
  3. How-To: Performance & Maintenance
    (2006 GMC Canyon) Any suggestions at this point will help the Rear differential fill plug is just fully rounded. Also where to buy a new fill plug would be nice. Thanks
  4. Lifting
    I was playing with the idea of doing a small 1.5 inch body lift on my truck, but it is the 5 speed so once I wouod install it the shifter would sit 1.5 inch down more and the boot would stay in place I am wondering if anyone else has done a body lift with a manual trans and how it turned out in...
  5. I4/I5 Engine & Drivetrain
    So I’m needing to pull my trans this weekend to replace my slave cylinder and his weekend. And I’m wondering if anyone has any tips or suggestions. What I’m thinking to do is remove the transfer case then the cross member and lower to trans a bit and then whole engine to get the top 3 bolts...
  6. Chassis
    Hi everyone. So I recently had to remove my front mud flapes and to remove the Screws easier I turned the steering wheel with the engine off in my garage all the way to lock, ether direction once. Now after starting my truck back up after about a week there are stiff/ binding spots about every...
  7. Lifting
    Hi, just a quick question. I’m installing a 3 inch tb crank and shackle lift on my truck soon. And I am aware that the front shocks do not need to be any longer. However I am not sure of the extended and compressed lengths. i know for the rear I’m looking for something in the realm of~ 15...
  8. Lifting
    Hi, just a quick question. I’m installing a 3 inch tb crank and shackle lift on my truck soon. And I am aware that the front shocks do not need to be any longer. However I am not sure of the extended and compressed lengths. i know for the rear I’m looking for something in the realm of~ 15...
  9. Engines/Performance/Tech Questions
    Just wanted to start out with huge fan of this website! But I’m not sure if anyone else has had this problem but when I’m driving at around 45mph (I’m guessing as soon as it gets into overdrive) my vehicle starts running rough and stays at 1500 rpms until I press harder on the gas pedal and it...
  10. Lifting
    Hey guys, I’m new to the site and I need some input so I don’t waste my money buying tires that don’t fit. I picked up an 08 colorado ext cab ls, and I got a 2.5 inch front and a 1.5 inch rear bracket and key lift/leveling kit, and I got 15x10 -47 offset. I’m hoping to wrap them in 32x11.5s with...
  11. Electrical/Lighting/Security
    My rear passenger window don’t go down, used to. When I click the button and it makes a sound, but i don’t know if it’s the motor or a relay.
  12. I4/I5 Engine & Drivetrain
    Hello all! this is my first time posting on here. I hope I'm posting this in the right spot... I have a 05 GMC Canyon. I came home from work yesterday, everything was fine and until i went to go leave again about 2 hours later. started the truck up fine then looked at my Instrument Cluster to...
  13. Wheels & Tires
    I am looking for a stock General Grabber HTS P215/70R16 99S B/W tire that’s in good condition because someone last night decided that they would see if their knife was sharp enough to slash the side wall. Thanks...
  14. Engines/Performance/Tech Questions
    so again, i looked on this site & saw some good ideas for mods to the engine to increase gas mileage & power & torque and stuff i wanna know what you guys have that was reasonable price wise and had improved your truck's performance & gas mileage. FYI i have a 3.5 I5 with a K&N air filter...
  15. Lowering
    hey so I looked all over this site and saw a lot of threads of how others lowered their z85s. It's really helpful but can be a handful. Can i have your guys inputs on the best & cheapest way to have a mild 2/3 drop on my z85? Just wanna know b/c i saw a lot of ways on here but not sure...
  16. New Member Introductions
    finally,maybe now i can get some answers!i've got a stock 07 z71 4wd single cab...and i'm wanting to fit 32's on it w/out rubbing,we just had are first child,so a big lift is out of the question.so what is the best way to fit the 32's?thought about a tb crank,but didn't know if that would be...
1-16 of 17 Results
Top