Chevrolet Colorado & GMC Canyon Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Chassis
    Hello everyone! I recently purchased a 2004 Canyon. While laying under it doing some maintenance (replacing the 4wd actuator), I discovered that the frame wasn't as solid as I had originally thought. After the initial disappointment, I decided to clean everything up, patch the small hole I found...
  2. Engines/Performance/Tech Questions
    Hey all, I am about to change out the fuel pump on my '10 colorado WT 2.9L and the Boschfuel pump I ordered states a new filter screen is required. Is it possible to reuse the old one, or should I buy a new one? And where can I get it?
  3. I4/I5 Engine & Drivetrain
    Has any one every had to replace this tube. I just had a replacement motor installed and my warranty company said it was not covered even though it was on the motor they sent the dealership. The dealership want $225 to install this. I was wondering how hard this is to do on my own? Any advice...
  4. I4/I5 Engine & Drivetrain
    I noticed last weekend when changing the oil that there was oil all over the bottom of the engine, trans and everything else. It looks like the front crankshaft seal that's leaking! It's pretty bad, I've gone through 3 quarts in a week. Has anyone ever done the front seal on a 2010 3.7l? Any...
  5. I4/I5 Engine & Drivetrain
    I just went to my local napa and had them check to see why my check engine light was on.It came back saying a temp sensor or thermostat.I have ordered the sensor,just need a pic of where it is located.I know where the thermostat is ,but hopeing it is the sensor instead.
  6. How-To: Interior
    Disclaimer The community here at urges you to please use caution and seek professional assistance when performing modifications to your vehicle. Before attempting any modification it is advised that you refer to your Colorado or Canyon service manual or contact a certified mechanic...
1-6 of 6 Results