Chevrolet Colorado & GMC Canyon Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. I4/I5 Engine & Drivetrain
    So I’m needing to pull my trans this weekend to replace my slave cylinder and his weekend. And I’m wondering if anyone has any tips or suggestions. What I’m thinking to do is remove the transfer case then the cross member and lower to trans a bit and then whole engine to get the top 3 bolts...
  2. Engine Swaps
    Hello, I am in the middle of putting another factory engine in my Colorado because the current engine has a cyl 5 valve problem. I have everything disconnected and unbolted that I can think of except for the bell housing bolts. There are a few that are easily accessible, but I am wondering how...
  3. I4/I5 Engine & Drivetrain
    alright folks, after much reading and investigation it looks like I will be changing the rear main seal on my 2008 colorado L2.9. over the last 6 months I have been monitoring the leak and it has gotten to a point where I feel the need to replace the seal in the very near future. In the...
1-3 of 3 Results
Top