Chevrolet Colorado & GMC Canyon Forum banner
1 - 20 of 24 Posts

· Registered
11 Posts
Discussion Starter · #1 ·
Hello all. Thanks for having me. I am starting a new build utilizing a LS2 I have on hand. Picked up a non-running 2006 single cab, short bed, 2wd, manual Colorado from Georgia on a Copart auction. Had it shipped here to Illinois and am tearing into it.
So far the build list includes but is not limited too
-LS2 with TSP Stg3 high lift truck cam. May swap for an MS3 b4 instalation.
-Factory 192k mile AR5 with Fabbot adapter and Cyber clutch
-Speed Engineering Headers (25-1066)
-Dual 3" exhaust with x pipe and bullet mufflers into center exit quad 4" tips
-Volant CAI
-V8 Colorado AC setup
-Fabbot lowpro trans member
-Fabbot pwr steering adapter
-Fabbot Cts-v front Brake upgrade kit
-Rear disc conversion
-Fabbot stainless brake lines
-Current Performance mounts
-CP Harness
-CP IGN switch
-Belltech 2/3 drop using ball joints and blocks
-Hummer H3 leather power seats and console
-Painted Ebony black interior
-Charcoal Carpet
-OneGuage digital dash with bezel
-9six9 18x9 wheels
-Nitto Nt555 G2 275/40 rear, 255/40 front
-Eaton Truetrac
-DNA motoring headlights and cargo light
-Akkon LED tail lights
-Xtreme Front end
-Roll pan
-z71 or Bushwacker flares

Here are a few pictures with more to come.
Tire Wheel Car Vehicle Automotive tire

Tire Automotive tire Motor vehicle Wheel Asphalt

Automotive tire Motor vehicle Automotive exterior Gas Auto part

Building Interior design Floor Flooring Gas

I hope some find this interesting. Please feel free to give me any advice or critiques, I'd love to hear your thought. Thanks.

· Registered
11 Posts
Discussion Starter · #4 ·
@spaddman Thanks for the welcome. I hope the trans will last a while. Fabbot has made 882hp on the dyno through one of these. I should be making roughly 425-450 at the tires. Fingers crossed. If it breaks, I will be exploring used t56s and CD009s.

· Registered
10 Posts
The h3 seats look sick!
I’m trying to figure out the best way to run some serious tread in the rear. I’ll probably shorten the rear end a few inches. Have to measure the wheels to be certain.

· Registered
11 Posts
Discussion Starter · #11 ·
Love the color on your truck, reminds me of ZR1 Jet Stream Blue. How wide of a tire are you trying to fit? My 18x9s on a 0 offset have plenty of room between the frame yet. You could likely get away with a 10in wide and a 305 with out modification.

· Registered
07 Chevy Colorado, 2.9L 5 speed manual
31 Posts
Got some most of the interior put back together today. Also installed a new Pioneer head unit and some Kicker CS series speakers. Kilmat was laid down on the cab floor, back of the cab and inside of the doors.
View attachment 345405
View attachment 345406
View attachment 345408
View attachment 345407
Love the H3 seats. I just need to find a manual transmission console top for mine, right now it's kinda Jerry rigged...
Car Vehicle Motor vehicle Steering part Car seat cover

Sent from my Pixel 5 using Tapatalk
1 - 20 of 24 Posts