Chevrolet Colorado & GMC Canyon Forum banner

1 - 20 of 28 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
So I had 2 inch blocks not too much of an issue they broke so now in doing the belltech 3's on a zq8 xtreme anyone have bump stop issues it looks super close??
 

·
Monkey Slut!
Joined
·
9,479 Posts
You did 3in leafs in the back? Yes you will be close to the large bumpstop, just take it out.
 

·
Monkey Slut!
Joined
·
9,479 Posts
Nope, just leave the small one in over the axle. Big one can go in the trash. :thumbup:
 

·
Registered
Joined
·
2,757 Posts
....waits until OP wants to go lower and has to notch frame....

(happens to the best of us)
 

·
US Army 19yrs and ......
Joined
·
45,284 Posts
I've been riding bump stops since 2005 lol
 

·
Monkey Slut!
Joined
·
9,479 Posts
Can you measure from ground up on the rear for me, center of the wheel to bottom of the lip?
 

·
Registered
Joined
·
2,757 Posts
Probably aluminum ones that corrode over time from contacting steel and salt.
 

·
Youngen!
Joined
·
6,515 Posts
Probably aluminum ones that corrode over time from contacting steel and salt.

Ehhh idk about that. I have had my 3" aluminum blocks for 4 years now. They are holding up amazing and I live in PA where they use a stupid amount of salt. I'll just say that my frame is Rusting out and so are my rockers but the blocks are fine. Now the u bolts are another story.


Sent from AutoGuide.com App
 
1 - 20 of 28 Posts
Top