[tahitiansoul]

Comp Cam XR265HR LS1 | eBay

This is the cam I bought on ebay. Any advice on which springs, or upgrades to do? Thanks

 

[djb383]

Try Comp Cams web site and see what they recommend for that cam.

 

[TurboAl]

you need springs, push rods and a trunnion upgrade

 

[tahitiansoul]

ls6 springs will do the job?

 

[TurboAl]

buy a good set of springs from Tooley or Comp or TSP, forget those stockers.

 

[itsfknkha]

Buy brian tooley 7.400 pushrods, ls6 springs (good up to .580 lift) and ull be set. No need for trunion upgrade unless u have a very aggressive cam or are pushing 600+hp. I've seen stock rockers go 800 hp with no problems

 

[05_quick4door]

Wow that's cheap!

Shove cam in hole. Yellow or blue gm springs if you want to go cheap.

Pacific springs is you want to spend a little more

Tooley, btr, or lunati if you want unnecessary double springs

 

[TooTall]

it's a great off idle cam, with no bottom end loss. The blue and yellow LS6 springs are good for .570 lift. That cam is refereed to as the 212/218 high lift.
It's a great beginner cam, no stall is needed, no rocker upgrades . . . reuse all of your stock parts

PAC 1218 .600 lift springs
any 7.4 hardened pushrods
and the cam

 

[itsfknkha]

Run ls6 springs. I've seen and used them on 580 lift cams revving to 6800 rpms with no valve float or coil bind. Best bang for the buck. Pac 1218 are damn good too but for the price u might as well but BTR 660 lift spring kit for 220. LS6 springs are cheap u can get them new for 60-80 bucks. Reason people say they're good for 570 lift is cause they play it safe. I've ran those springs on plenty of builds with proven results and no broken springs after 100k miles

 

[TurboAl]

I used the Pac 1218 springs and Tooley 7.4 push rods and Comp trunnions.
i have seen to much stock stuff break, i'll spend a few extra bucks to be safe.
my 2'C.

 

[tahitiansoul]

I can have these springs for $65, what do you think guys?
PSI LS1511 Max Life Beehive GM LS LS1 LS6 Premium Valve Spring 625" Max Lift | eBay

 

[05_quick4door]

Usually I'm all over ebay Chong parts. That being said I would not buy those. I don't have personal experience but I have seen pictures of one that broke. And took a shiny 6.0 with it

 

[05_quick4door]

In my trials, you need to spend money on converter,cam, and springs. Everything else is irrelevant

 

[TurboAl]

that cam is very similar to mine, 210/224 .556/.568 114 LCL
no converter needed. good low end cam. Too Tall is right on with
the springs and push rods. i used them.