Chevrolet Colorado & GMC Canyon Forum banner
1 - 1 of 1 Posts

2 Posts
Discussion Starter · #1 ·
Hi, I've been lurking around hear for a few weeks. I have a dead Colorado at the moment, typical anti theft bull. There's a lot of good information on the whole VAT and BCM troubles that plague GMs here. But the one vital piece of information I need, I cannot seem to find anywhere.

So, does anyone know what pin/wire does the "Enable injector signal" reside at, on either the BCM connectors in the passenger kick panel or the ECM connector of an '04 2.8 Colorado?

The ECM is a three plug MT88 style, with blue, black and gray connectors.


Is there a pinout for the BCM/PCM of this truck, perhaps I have overlooked while searching on the forum?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.