Chevrolet Colorado & GMC Canyon Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
19,139 Posts
Discussion Starter #1
I need to pick up some grill mesh for the new grille as well as the bumper. These pieces are not made, so I have to find some sheets.

Right now, I am looking into some silver mesh like this: customcargrills.com - Perforated GT Aluminum Grill Mesh Sheets

It's the perforated, similar to the SS grilles people run.

I need two pieces, one being 12"x36" for the grille and 6"x30" for the bumper (minimum sizes).

I know about customcargrills.com, hence the link above. Just looking to see if anyone has access to stuff like that for cheaper than what they are trying to charge... :shrug:
 

·
SOLD!!!
Joined
·
4,508 Posts
That was the only place I could find what I needed. They do have a "Scrap Pile" link for mis-cuts and leftover stuff.
 

·
Premium Member
Joined
·
19,139 Posts
Discussion Starter #3
Yeah, checked the scrap but didn't see anything in there.

In a wait right now to actually finish the grille and send it off to paint since I am close. Need to do a little welding on it and then sand it down.

Figured that I would post up here during this hiatus that I am forced to wait to see if someone has access to something.. :shrug:
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top