[1LORADO]

Hey everyone,

Quick question. I have a Z85 that is lowered 2" all around (2" BJ's / 2" Blocks), and I want to take it a little lower. I'm selling off my current 20's and getting some new ones w/ P255/35R20 rubber, and just wondering what the best way to apporach this would be.

I'm thinking of getting the 1" coils and cutting them to 1 3/4, and then getting the 2" leafs, ending up in a 3 3/4 front, 4 rear.

Am I going to rub like a bastard in the front? Or should I just go 2" coils and knock out my inners a little bit?


Thanks boys :cheers

 

[rrcn]

Get some 1" coils for the front and that's done.

As for the rear, there are no 2" leafs.

Either swap for 4" blocks or go with the 3" leafs with 1" blocks.

And the 255/35-20's will be just fine. You may experience a slight rubbing from the driver's side inner fender, but it's not a huge deal.

 

[for20]

Get some 1" coils for the front and that's done.

As for the rear, there are no 2" leafs.

Either swap for 4" blocks or go with the 3" leafs with 1" blocks.

Yeah that....PLus...it'll probably ride better too.

 

[1LORADO]

Get some 1" coils for the front and that's done.

As for the rear, there are no 2" leafs.

Either swap for 4" blocks or go with the 3" leafs with 1" blocks.

And the 255/35-20's will be just fine. You may experience a slight rubbing from the driver's side inner fender, but it's not a huge deal.

Presuming the coils will settle a little lower after a while?

 

[rrcn]

Well, they'll settle...but not that much.

If you want them to drop you more, your only option is to cut 'em.

Each 1/2 coil is about a 1/2".

 

[1LORADO]

Who makes a 4" drop block? I can't seem to find anything on Summit...

 

[rrcn]

DJM does.