Chevrolet Colorado & GMC Canyon Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
Hey Everyone,
Just wanted to share my new SOA lift and some info with everyone.

I headed to Virgina to have Kenny help me with this lift. As most of you know Kenny is an amazing guy with a wealth of knowledge and skill.

The front: Readylift sst 2.5" then added 3" spindles

The Rear: SOA

Parts list: RuffStuff GM 2.5" Wide Spring Perch,U bolt, 5/8" x 3 1/4" x 10",GM U Bolt Plates (2.5" Springs), Shock tabs were ones Kenny had laying around.

Kenny dropped the carrier bearing and made a custom bracket. The drive shaft came up a bit short. The Ruffstuff perches and and plates have 3 holes for placement on the springs. we set the axle on the last hole, this allowed the drive shaft to reach and sit like it does stock in the trans.

please excuse the filthy truck from the drive.




 

·
Registered
Joined
·
1,104 Posts
awesome work man!
 

·
Premium Member
Joined
·
10,390 Posts
Looking good George glad to see it in the daylight . Haha you left out a ton of details of all the Ohio rust on the brakes ! Was great hanging out with you and glad I could help you get your truck lifted and do a complete brake overhaul lol
 

·
Registered
Joined
·
510 Posts
awesome look! what size tire you run?
 
1 - 7 of 7 Posts
Top