Chevrolet Colorado & GMC Canyon Forum banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Just replaced my toasted 2012 front rotors tonight.. What a chore I must say.. The hub design is much different compared to the older models.. The rotor assembley doesn't like to slide off as easily as I've witnessed for the older models..

After an hour of beating on the rotor.. I decided I was wasting my time. Small piece of 2x4 tucked behind the rotor and fit snug against the the truck up and twist the wheel a time or two.. Pops right off. Figured this may save someone else the headache.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.