Chevrolet Colorado & GMC Canyon Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Just lowered my 2012 with Belltech drop ball joints and Belltech lowering springs in the front, the rear I did 4”blocks and pulled the last leaf out.

I want to go lower. Looks like about I can get another 1 1/2 inch till the frame hits, I’ll c-notch it. The front can go a few inches Lowe till the bumps stops hit. I want to cut coils out of the lowering springs and wondered if any of you guys have and how much to cut? I don’t care about the ride so worry about all that.
 
1 - 1 of 1 Posts
Top