it just pops of. you may have to take the set belt loose to get it off. no big job.:drinking28:

 

Step 1: Grab panel
Step 2: PULL!!!!!!
lol
Welcome to the forum!!!!

My rattle was from the bolt that holds the seat and middle seatbelt down was not tight so the bracket was bouncing around. Tightened the bolt and it went away. :thumbup:

 

If you have a crew cab I found my rear rattle to be the seats themselves.. haven't fixed it yet either.. I need to do this..

 

I have tried starting threads in the proper area but always get a message that I need 10000000000000000000000 posts to start a thread, that's why this is here.

There is not any post count restrictions for starting new threads except in the classified area. If you getting this error contact one of the admins. @Supermodulation @blurred @Admin

 

Thanks guys, I should have added that I have a standard cab and the panels that I am really wondering about are the one with the little vent in it behind the door and the one above that, that runs up to the headliner with the seatbelt stanction.

 

Standard cab panels are easy, just pull. Top one you'll have to remove the bolt for the seat belt. The back panel will have to come off first, it locks in the side panel.

 

Thanks, I'll get after it. Thinking maybe something fell down the slot the seat belt goes into.

 

Hi carpenter,

I know this isn't related to your original question but can you please take a screenshot of the post requirement message?

Thank you.

~Kay

 

Hope this works

 

:welcome2:

 

Directly posting in the How-To/Tutorials/Reviews/Service Bulletins is locked and the only way to submit something for those sections is to post a submission thread in the "How-To: Submissions" section.

~Kay